Sirius Satellite Radio SRS-2VB User Manual download pdf (Page 13)

Home Distribution Kit Installation Manual

you are locating the Splitter. When routing the antenna cable, be careful not

to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture the

external jacket of the antenna cable.

Connect the cable from the antenna to the IN port on the Splitter as shown.

(Refer to page 3 for the Splitter port identication.) Note that you must use

the Splitter even if you are only connecting one SIRIUS radio.

OUT1 OUT2

Connect another RG-6 cable to the OUT1 connector of the Splitter and route

the cable to the SIRIUS radio. (Refer to page 3 for the Splitter port identica-

tion.)

Connect one of the supplied RG-174 adapter cable to the RG-6 cable, and

connect the other end of the RG-174 cable to the ANT connection on the

SIRIUS radio.

Repeat steps 5 and 6 if you are connecting a second SIRIUS radio, this time

using the OUT2 connector of the Splitter. If you will not be connecting a sec-

ond radio, connect the provided terminator to the unused OUT2 connector

on the splitter. (Refer to page 3 for the Splitter port identication.)

OUT1 OUT2

{

Use terminator if no second receiver

The installation of the Home Distribution Kit is now completed. The completed

installation for two SIRIUS radios should be as shoen in the following illustrations:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Sirius Satellite Radio SRS-2VB User Manual Page 13