Sirius-satellite-radio ACCURIAN 6.1ch Sirius-Ready A/V Surround Receiver User Manual download pdf (Page 10)

Connecting Speakers

Caution: To avoid damaging the speakers with a sudden high-level

signal, be sure to switch the power oﬀ before connecting the speakers.

• Check the impedance of your speakers.

• Connect speakers with an impedance of 6 ohms or more.

• The ampliﬁ er’s red speaker terminals are the positive (+) terminals and

the black terminals are the negative (-) terminals.

• The + side of the speaker cable is marked to make it distinguishable from

the - side of the cable. Connect this marked side to the red + terminal

and the unmarked side to the black terminal.

• Prepare the speaker cords for connection by stripping oﬀ approximately

10 mm or less (no more, as this could cause a short circuit) of the outer

insulation. Twist the wires tightly together so that they do not fray:

How to Connect

1. Loosen the knob by turning it counterclockwise.

2. Insert the bare part of the wire into the hole inside of each terminal.

3. Tighten the knob by turning it clockwise to secure the wire.

Note: Make sure the cord is fastened securely by pulling it lightly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Sirius-satellite-radio ACCURIAN 6.1ch Sirius-Ready A/V Surround Receiver User Manual Page 10